Installing The Fillers; Installing Fillers For Rs-232/Rs-485 Printers - IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

August 24, 2004

Installing the fillers

Installing fillers for RS-232/RS-485 printers

Notes:
1. On an integrated unit, pull out on the locking lever at the left side of system unit.
2. Ensure that the side of each filler overlaps the tab on the side of the system
To install fillers:
1. Power the system off and disconnect the RS-232 power supply (if connected).
2. If you have a video display on an integrated system:
3. If you do not have a video display, place the display filler on the system unit. Do
4. If you have a short keyboard, place the keyboard filler beside the keyboard. See
5. Place the printer filler beside the display filler. Make sure you route the printer
unit.
See Figure 5 on page 18.
a. Move the display on its arm to the side and remove any tape holding the
alignment ring.
b. Remove the knockout section of the display filler.
c. Align the display filler with the alignment ring and slide the filler onto the
ring. Press the display filler into place. See Figure 13 on page 26.
not remove the knockout section. See Figure 13 on page 26.
Figure 13 on page 26.
cable to the side, as shown in Figure 13 on page 26.
Chapter 2. Installation instructions
25