Tools And Supplies Needed; System References; Installation Instructions For Intel® Server Chassis Sc5300/Sc5400; Remove Access Cover - Intel SC5300BASE Install Manual

Local Control Panel Kit Installation Instructions

Tools and Supplies Needed

•
Phillips* (cross head) screwdriver (#1 bit and #2 bit)
•
Anti-static wrist strap and conductive foam pad (recommended)

System References

All references to left, right, front, top, and bottom assume the reader is facing the front of
the chassis as it would be positioned for rack-mount operation.
Installation Instructions for Intel® Server Chassis SC5300/
SC5400
Note: This section only applies to Local Control Panel kit installations for the Intel® Server
Chassis SC5300/SC5400. If you are installing a Local Control Panel kit into an Intel®
Entry Server Chassis SC5275-E, follow the instructions under
for Intel® Entry Server Chassis SC5275-E" on page
Control Panel kit into an Intel® Entry Server Chassis SC5299-E, follow the instructions
under "Installation Instructions for Intel® Entry Server Chassis SC5299-E" on page

Remove Access Cover

1. Unplug all power and peripheral cables from the chassis.
2. If necessary, remove shipping screw from the back of the chassis cover (see letter "A"
in the following figure). Release latch (see letter "B") and remove access cover.
2
A

Figure 1. Removing Access Cover

"Installation Instructions
12. If you are installing a Local
B
TP00527
Local Control Panel Kit Install Guide
19.