Installing The Npe-G1 And Npe-G2 Optical Cable-Management Bracket; Installing The Brackets On The Rear Of The Chassis - Cisco 7206VXR - VPN Bundle Router Configuration Manual

Chapter 3 Installing a Cisco 7200 VXR Router

Installing the NPE-G1 and NPE-G2 Optical Cable-Management Bracket

Figure 3-9
1
1
Loosen the left and right captive installation screws.
Step 1
Hold the cable-management bracket so that it is positioned as shown in
Step 2
Place the left end of the cable-management bracket over the screw.
Step 3
Rotate the cable-management bracket down, until it slides behind the right captive installation screw.
Step 4
Tighten both captive installation screws.
Step 5
Step 6 Install the cables, and fasten them to the cable-management bracket with the straps provided.

Installing the Brackets on the Rear of the Chassis

To install the rack-mount and cable-management brackets on a Cisco 7200 VXR router for a rear
rack-mount configuration, complete the following steps:
Locate the threaded holes in the rear sides of the chassis.
Step 1
Align the first rack-mount bracket to the threaded holes in the right side of the chassis.
Step 2
If you want the front of the chassis protruding from the rack, align the rack-mount bracket to the chassis
as shown in
bracket to the chassis as shown in
OL-5013-09
Installing the NPE-G1 and NPE-G2 Optical Cable-Management Bracket
G I G A B I T E T H E R N E T 0 / 1
G I G A B I T E T H E R N E T 0 / 1
L I N K
L I N K
E N
E N
R J 4 5
R X G B I C T X
R J 4 5 R X G B I C
Left captive installation screw
Figure 3-10. If you want the front of the chassis recessed in the rack, align the rack-mount
G I G A B I T E T H E R N E T 0 / 1
NETWORK PROCESSING ENGINE - G1 NETWORK PROCESSING ENGINE-300
L I N K
C P U
R E S E T
E N
T X R J 4 5
R X G B I C T X
C O M PA C T F L A S H
2
Right captive installation screw
Figure 3-11.
Cisco 7200 VXR Installation and Configuration Guide
Rack-Mounting a Cisco 7200 VXR Router
S L O T
A C T I V E
POWER
CONSOLE
OK AUX
2
Figure 3-9.
3-11