Parallel Devices - NEC Versa User Manual

Parallel Port

Parallel Devices

Note: in Windows, when you connect a printer, be sure to install the appropriate printer driver through the
Control Panel.
Connect a parallel device to your system as follows.
1. Check that power to both the Versa and the device is off.
2. Align and connect the 25-pin parallel cable (small end) connector to the port on the system and
either lock the connector clips or secure the thumb screws.
3. Align and connect the other end of the cable to the parallel port on the device. Either lock the
connector clips or secure the thumb screws.
4. Connect the power cable to the device and a properly grounded wall outlet.
5. Follow any specific set-up instructions in the device's user's guide.
6. Turn on power to the system and the device.
Note: check that the device is online before you try to use it. Refer to the device's documentation for
instructions.