Attaching Scsi Drive Cables - NEC VERSA DOCKING STATION 6000 Manual

11.
12.

Attaching SCSI Drive Cables

Attach SCSI drive cables as follows.
cable. If you are installing Plug and Play SCSI drive, purchase a ca-
ble that comes with a terminated connector.
1.
If you have nothing else to install, replace the docking station cover as
described in "Cover Replacement."
Proceed as follows:
n
If you have a Plug and Play system, simply dock the NEC Versa and
reboot your system. The NEC Versa automatically detects the new
drive.
n
If you do not have a Plug and Play system, run Setup to set your
new configuration.
To install a SCSI drive, you must purchase an optional SCSI
Locate the SCSI cable connector on the docking station interface board.
The cable should look similar to the one shown in the following figure.
Adding Options 4-41