Table of Contents
Advertisement
Installation
Follow these steps to install an expansion board in the docking station.
1.
Be careful not to drop anything into the docking station. Doing so
can damage the unit.
4-8 Adding Options
Prepare for board installation as follows:
n
Disconnect and remove the NEC Versa from the docking station.
n
Turn off and unplug the docking station.
n
Disconnect any peripheral devices connected to the docking station.
n
Remove the docking station cover. See "Cover Removal" earlier in
this section for information on removing the cover.
n
Position the docking station so you have access to the side where the
expansion slots are located.
PCI and ISA slot locations
CAUTION
Advertisement
Table of Contents
Need help?
Do you have a question about the VERSA DOCKING STATION 6000 and is the answer not in the manual?
Questions and answers