Undocking The Nec Versa; Normal Undocking - NEC VERSA DOCKING STATION 6000 Manual

After docking the NEC Versa for the first time, you do not always need to
use the power button to power on your system. If the docking station re-
mains plugged in and the main power switch on the back of the unit stays
turned on, the NEC Versa automatically powers on after docking. If you
turn off AC power through the main power switch or by unplugging the
docking station, you must use the power button the first time you dock your
NEC Versa.

UNDOCKING THE NEC VERSA

NEC recommends that you power down your NEC Versa before undocking.
n
n

Normal Undocking

Undock your NEC Versa as follows.
1.
2.
2-10 Docking/Undocking the NEC Versa
For standard undocking procedures, follow the instructions in "Normal
Undocking."
If power to the docking station is interrupted unexpectedly, follow the in-
structions in "Emergency Undocking." You may need this procedure in
case of a power failure or motor jam.
Check the status of your NEC Versa power:
n
If you are running Windows 95, you can either put your system into
Suspend mode or leave the system operating to undock.
n
If you are running Windows for Workgroups, save your files, and
power off your NEC Versa. (To power off the NEC Versa, press the
power button on the front panel of the docking station.)
For easier undocking, close the LCD panel.(This is not required, but is
recommended.) If using software undocking, do not close the panel.