NEC VERSA DOCKING STATION 6000 Manual page 100

Lower the CRT base onto the docking station.
2.
Carefully center the external monitor on the CRT base or place it on the
3.
desk.
Be sure to center the monitor on the CRT base and docking station
(see the following figure). Putting the monitor too close to the edge
can cause the monitor to fall, causing possible harm or damage.
4. Attach the 15-pin connector on the signal cable to the monitor port on the
docking station.
Lowering the CRT base into place
WARNING
Connecting Peripheral Devices 5-3