Table of Contents
Advertisement
See the next section, "Docking Station 6000 Setup Software," for informa-
tion about using Docking Station 6000 software.
Docking Station 6000 Setup Software
This section describes how to use the software that the Docking Sta-
tion 6000 Setup utility loads in your NEC Versa. At start up, the NEC
Versa lets you choose a configuration to use. See "Choosing a Configura-
tion" for information.
Choosing a Configuration
After setting up the Docking Station 6000 software, your NEC Versa boot-
up differs from its original procedure. The new boot up sequence lets you
choose which configuration to use.
Use the new boot up procedure as follows:
1.
2.
Option Configuration
Follow the instructions that come with your option to configure devices in-
stalled in the Docking Station 6000.
If your NEC Versa BIOS, its operating system, and the option are all Plug
and Play-compliant, you should be able to install the option, reboot your
system, and use the option. Check the documentation that came with the
optional device to determine whether or not the option requires special
drivers. If it does, load the drivers according to the instructions that come
with the option.
Power on your NEC Versa as you would normally. A menu similar to the
following is displayed.
1. Mobile Configuration
2. Docking Station Configuration
Enter the appropriate number for the configuration you want to use as
follows:
n
Mobile Configuration — Select this configuration to use the NEC
Versa by itself.
n
Docking Station Configuration — Use this configuration when you
dock your NEC Versa on the Docking Station 6000.
Setting Up and Using the Software 3-5
Advertisement
Table of Contents
