Table of Contents
Advertisement
Changing the Network Configuration
Use the Network Configuration menu to set the bootup option and
configure the switch's IP parameters. The screen shown below is
described in the following table.
Parameter
IP Address
Subnet Mask
Gateway IP
Description
IP address of the switch you are managing. The system
supports SNMP over UDP/IP transport protocol. In this
environment, all systems on the Internet such as
network interconnection devices and any PC accessing
the agent module (or running EliteView) must have an
IP address.
Valid IP addresses consist of four numbers, 0 and 255,
separated by periods. Anything outside this format will
not be accepted by the configuration program.
Subnet mask of the switch. This mask identifies the
host address bits used for routing to specific subnets.
Gateway used to pass trap messages from the system's
agent to the management station. Note that the gateway
must be defined if the management station is located in
a different IP segment.
M
S
ANAGEMENT
M
ETUP
ENU
3-13
Advertisement
Table of Contents
