SMC Networks 6724L2 - annexe 1 Management Manual page 13

or above), or from a network computer using network
management software such as
Notes: 1. By default BOOTP is disabled. To enable BOOTP, see
"IP Configuration" on page 2-12.
2. Up to four simultaneous Telnet sessions are supported
by this switch.
3. The on-board program only provides access to basic
configuration functions. To access the full range of
SNMP management functions, you must use SNMP-
based network management software, such as SMC's
free EliteView software.
R
EliteView
C
EQUIRED ONNECTIONS
1-3