14.4.3 Example - Using The Ftp Command From The Dos Prompt; Figure 14-10 Menu 24.7.1 As Seen Using Telnet; Figure 14-11 Ftp Session Example; Table 14-2 Third Party Ftp Clients - General Commands - ZyXEL Communications PRESTIGE 1400 User Manual

To upload the router firmware, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your Prestige. Then type "root" and your SMT
password as requested.
3. Type "put firmwarefilename ras-m" where "firmwarefilename" is the name of your
firmware upgrade file on your workstation and "ras-m" is the remote file name
on the Prestige. Specify "ras-m" as the remote filename if you want to upload
firmware from your workstation into the main block or "ras-b" if you want to
upload firmware into the backup block.
4. The system reboots automatically after a successful firmware upload.
For details on FTP commands, please consult the documentation of your FTP client
program. For details on uploading router firmware using TFTP (note that you must
remain in menu 24.7.1 to upload router firmware using TFTP), please see the
Prestige manual.
Press ENTER to Exit:

14.4.3 Example - Using the FTP command from the DOS Prompt

Use "put" to transfer files from the workstation to the Prestige, e.g., put prestige.bin ras transfers the
firmware on your computer ("prestige.bin") to the Prestige and renames it "ras". Type "quit" to exit the ftp prompt.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put prestige.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 327680 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
The following table describes some of the fields that you may see in third party FTP clients:
COMMAND
Host Address
Login Type
Transfer Type
Initial Remote Directory
Initial Local Directory
Configuration & Firmware Maintenance
Menu 24.7.1 – Upload ZyNOS code using FTP

Figure 14-10 Menu 24.7.1 as seen using Telnet

Figure 14-11 FTP Session Example

Note: The system reboots after a successful upload.

Table 14-2 Third Party FTP Clients - General Commands

Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the
server for anonymous access. Anonymous logins will work only if your
ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Specify the default remote directory (path).
Specify the default local directory (path).
Prestige 1400 WAN Router with Integrated Ethernet Switch
DESCRIPTION
14-7