Rear Panel - Power Connection; Front Panel Leds; Figure 3-2 Prestige Rear Panel - ZyXEL Communications PRESTIGE 1400 User Manual

Connecting Local Application Servers
Connect a local application server such as web, e-mail, video, gaming, building automation etc. to port 15 (reserved
by default) of the integrated Ethernet switch. If you wish to connect more than one local application server, then
either hook them up via a hub connection to port 15 (shared bandwidth tradeoff) or to port 1 to 14, but remember to
make that port visible to the entire switch (see next).
Connecting the VLAN Configuration Port
In case you need to change the default Virtual LAN (VLAN) configuration of the integrated Ethernet switch, use a
terminal emulator on a computer and connect it to the VLAN CONF. port. Connect the RJ-11 connector end of the
supplied cable to the VLAN CONF. port of the switch and the 9-pin end to a serial port (COM1, COM2 or other
COM port) of your computer.
Please exercise caution when changing the default switch VLAN configuration as there may be security
3.4 Rear Panel – Power Connection
The following figure shows the rear panel of the Prestige. Connect one end of the power cord to the receptacle
labeled AC INPUT on the rear panel of your Prestige and the other end to the power outlet. Make sure that no
objects obstruct the operation of the fan (to the left of the power receptacle).
3.5

Front Panel LEDs

After you have finished making the connections to the Prestige, turn the Prestige on by using the switch on the rear
panel and then make sure all connections are correct by checking these LEDs. These LEDs are also useful as
troubleshooting aides. The following figure and table describe the front panel LEDs of the Prestige.
Hardware Installation & Initial Setup
Prestige 1400 WAN Router with Integrated Ethernet Switch
ramifications.

Figure 3-2 Prestige Rear Panel

3-3