The ISP gives you IP addresses of a.b.c.1 to a.b.c.5. The corresponding private IP addresses are 192.168.1.1 to
192.168.1.5 inclusive. We wish to map public IP addresses a.b.c.2 to a.b.c.5 to the phoneline switches.
"a.b.c.digit" represents a real, public IP address - alphabetical characters cannot be accepted as parts
12.5.1 Procedure to Set Up NAT for Remote Management
Pick an available NAT set from Menu 15.1. Let's say set 1 is available.
Step 1.
Go to Menu 15.1.1.1 (see the NAT chapter for details) and configure the screen as shown.
Step 2.
After you configure this screen, press [ENTER] to go back to this screen.
Step 3.
Remote Management
Menu 15.1 - Address Mapping Sets
Figure 12-3 Pick An Address Mapping Set
Menu 15.1.1.1 Address Mapping Rule
Type= One-to-One (range)
Local IP:
Start= 192.168.1.2
End
= 192.168.1.5
Global IP:
Start= a.b.c.2
End
= a.b.c.5
Press ENTER to Confirm or ESC to Cancel:
Figure 12-4 Address Mapping Rule
Prestige 1400 WAN Router with Integrated Ethernet Switch
of an IP address.
1. NAT_SET1
2. NAT_SET2
3. NAT_SET3
4. NAT_SET4
255. SUA (read only)
12-3