Table of Contents
Advertisement
Press ENTER to Confirm or ESC to Cancel:
The following table describes the SNMP configuration parameters.
FIELD
Get Community
Set Community
Trusted Host
Trap: Community
Trap: Destination
Once you have completed filling in Menu 22 - SNMP Configuration, press [ENTER] at the
message "Press ENTER to Confirm..." to save your configuration, or press [ESC] to cancel.
10.4
SNMP Traps
P1400 will send traps to the SNMP manager when any one of the following events occurs:
1.
coldStart (defined in RFC-1215) :
When the machine coldstarts, a trap will be sent after booting (power on).
2.
warmStart (defined in RFC-1215) :
When the machine warmstarts, a trap will be sent after booting (software reboot).
3.
linkDown (defined in RFC-1215) :
When any of the links are down, a trap will be sent with the port number. The port number is its interface index
under the interface group.
Port 1 : Ethernet LAN
SNMP Configuration
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Hgst= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
Figure 10-2 Menu 22 - SNMP Configuration
Table 10-1 SNMP Configuration Menu Fields
DESCRIPTION
Enter the Get Community, which is the password for the
incoming Get- and GetNext- requests from the management
station.
Enter the set community, which is the password for
incoming Set requests from the management station.
If you enter a trusted host, your Prestige will only respond to
SNMP messages from this address. If you leave the field
blank (default), your Prestige will respond to all SNMP
messages it receives, regardless of source.
Enter the trap community, which is the password sent with
each trap to the SNMP manager.
Enter the IP address of the station to send your SNMP traps
to.
Prestige 1400 WAN Router with Integrated Ethernet Switch
OPTION
Public
Public
Blank
Public
Blank
10-3
Advertisement
Table of Contents
Troubleshooting
