Using The Ftp Command From The Dos Prompt Example; Tftp File Upload; Figure 11-8 Ftp Session Example - ZyXEL Communications Prestige 650H-17 User Manual

Prestige 650H-17 ADSL Router

11.4.3 Using the FTP command from the DOS Prompt Example

Step 1.
Launch the FTP client on your computer.
Step 2.
Enter "open" and the IP address of your Prestige.
Step 3. Press [ENTER] when prompted for a username.
Step 4. Enter "root" and your SMT password as requested. The default is 1234.
Step 5.
Enter "bin" to set transfer mode to binary.
Step 6. Use "put" to transfer files from the computer to the Prestige, e.g., put firmware.bin ras transfers
the firmware on your computer (firmware.bin) to the Prestige and renames it "ras". Similarly
"put config.rom rom-0" transfers the configuration file on your computer (config.rom) to the
Prestige and renames it "rom-0". Likewise "get rom-0 config.rom" transfers the configuration
file on the Prestige to your computer and renames it "config.rom." See earlier in this chapter for
more information on filename conventions.
Step 7.
Enter "quit" to exit the ftp prompt.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 327680 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
More commands that you may find in third party FTP clients, are listed earlier in this chapter.
FTP over WAN will not work if you have applied a filter in menu 11.5 (WAN) to block Telnet service.

11.4.4 TFTP File Upload

The Prestige also supports the up/downloading of the firmware and the configuration file using TFTP
(Trivial File Transfer Protocol) over LAN. Although TFTP should work over WAN as well, it is not
recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware and the
configuration file, follow the procedure shown next:
11-8

Figure 11-8 FTP Session Example

Firmware and Configuration File Maintenance