Prestige 1400 WAN Router with Integrated Ethernet Switch
FIELD
RIP Direction
Version
Multicast
IP Policies
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
5.4
Collecting Internet Account Information
Before you configure your Prestige for Internet access, you need to collect your Internet account information from
your ISP. The type of information you need to gather depends on your Prestige interface to the Internet –
FlexWAN or Ethernet. Use Table 5-4 to record your Internet Account Information.
INTERNET ACCOUNT INFORMATION WRITE YOUR ACCOUNT INFORMATION HERE
Local IP Addr
Subnet Mask
Gateway IP Addr
Login Name
Password
Frame Relay Options (if applicable)
5.5
Internet Access using the Prestige
Menu 4 allows you to enter the Internet access parameters in one screen. Menu 4 is actually a simplified setup for
one of the remote nodes that you can access through menu 11. From the main menu, enter option 4 to go to Menu 4
- Internet Access Setup, as displayed in the next figure.
5-4
subnetting, use the subnet mask computed by the Prestige
Press [SPACE BAR] to select the RIP direction from Both/In
Only/Out Only/None.
Press the [SPACE BAR] to select the RIP version from RIP-1/RIP-
2B/RIP-2M.
IGMP (Internet Group Multicast Protocol) is a session-layer
protocol used to establish membership in a Multicast group. The
Prestige supports both IGMP version 1 (IGMP-v1) and IGMP-v2.
Press [SPACE BAR] to enable IP Multicasting or select None
(default) to disable it.
You can apply up to four IP Policy sets (from twelve) by entering
their numbers separated by commas, e.g., 3, 4, 6, 11.
Only one Internet interface can be active at any one time.
Table 5-4 Internet Account Information
Internet Access Interface= Ethernet
Internet Access Interface= FlexWAN
DESCRIPTION
EXAMPLE
Both
(default)
RIP-1
(default)
None
Internet Access