Chapter 3.
This chapter describes all of the basic network configuration tasks which include the
Ports, Layer 2 network protocol (e.g. VLANs, QoS, IGMP and ACLs etc.) and any
setting of the Switch.
3-1 Port
The section describes to configure the Port detail parameters of the switch. Others you could
using the Port configure to enable or disable the Port of the switch. Monitor the ports content
or status in the function.
3-1.1 Configuration
This chapter describes how to view the current port configuration and how to configure ports to
non-default settings, including
Linkup/Linkdown
Speed (Current and configured)
Flow Control (Current Rx, Current Tx and Configured)
Maximum Frame Size
Excessive Collision Mode
Power Control.
Web Interface
To configure an Current Port Configuration in the web interface:
1. Click Configuration, Port, then Configuration
2. Specify the Speed Configured, Flow Control , Maximum Frame sze ,
Excessive Collision mode and Power Control.
3. Click Apply.
Configuration
XGS3600 Series User's Guide
35