Table of Contents
Advertisement
Chapter 5. Applying Effects to the Sound
Applying Effects in Patch Mode
In Patch mode you can use one multi-effect (MFX), one chorus, and one reverb.
Signal Flow and Parameters (EFFECT ROUTING)
Here you can make overall settings for effects, such as the output destination and level of the various signals.
fig.Routing
1
2
5
3
4
6
For details on how to make settings, refer to "Making Effect Settings" (p. 79).
Parameter
Tone Select
1
(Rhythm Key Select)
Tone Output Level
2
Tone Chorus Send
3
Level
Tone Reverb Send
4
Level
MFX Type
5
Patch Output Assign
(Rhythm Output
Assign)
6
Tone OUTPUT
Assign
MFX Output Level
7
MFX Chorus Send
8
Level
MFX Reverb Send
9
Level
Chorus Type
10
80
7
10
12
8
11
13
9
Range
Explanation
The tone (rhythm tone) to edit
1–4
(A0–C8)
If you've selected a rhythm set, this will be Rhythm Key Select.
0–127
Level of signal sent from each tone to the destination specified by Output Assign (
0–127
Level of signal sent from each tone to the chorus
0–127
Level of signal sent from each tone to the reverb
Type of multi-effect to use (choose one of 79 types)
0–79
For details on each multi-effect, refer to "Multi-Effects Parameters (MFX1–3, MFX)" (p. 163).
Specifies how the unprocessed sound of the patch (rhythm set) will be output
If you've selected a rhythm set, this will be Rhythm Output Assign.
MFX,
MFX: Output in stereo via the multi-effect. Chorus and reverb can also be applied after the multi-
L+R,
effect.
L,
L+R: Output in stereo from the OUTPUT jacks without passing through the multi-effect
R,
L: Output in mono from the OUTPUT L jack without passing through the multi-effect
TONE
R: Output in mono from the OUTPUT R jack without passing through the multi-effect
TONE: Output according to the settings of each tone
Specifies how the unprocessed sound of each tone will be output
MFX: Output in stereo via the multi-effect. Chorus and reverb can also be applied after the multi-
effect.
L+R: Output in stereo from the OUTPUT jacks without passing through the multi-effect
MFX,
L: Output in mono from the OUTPUT L jack without passing through the multi-effect
L+R,
L,
R: Output in mono from the OUTPUT R jack without passing through the multi-effect
R
* The setting you specify here is valid only if Patch Output Assign is set to "TONE."
* If Structure (p. 99) is set to TYPE 02–10, the settings for tone 1 (3) will follow the settings of tone
2 (4). (This is because the outputs of tones 1 and 2 are combined into tone 2, and the outputs of
tones 3 and 4 are combined into tone 4.)
0–127
Volume of the sound that has been processed by the multi-effect
0–127
Amount of chorus applied to the sound that has been processed by the multi-effect
0–127
Amount of reverb applied to the sound that has been processed by the multi-effect
Type of chorus
0 (OFF): Chorus/delay will not be used
1 (CHORUS): Chorus
0–3
2 (DELAY): Delay
3 (GM2 CHO): GM2 chorus
)
6
Advertisement
Table of Contents
