Precautions - Icom IC-PW2 Instruction Manual

PRECAUTIONS

R DANGER HIGH RF VOLTAGE! NEVER touch an
antenna or antenna connector while transmitting or
tuning. This could cause an electrical shock or burn.
R DANGER! NEVER operate the linear amplifier near
unshielded electrical blasting caps or in an explosive
atmosphere. This could cause an explosion and
death.
R WARNING! NEVER use the linear amplifier
during a lightning storm. It may result in an electric
shock, cause a fire or damage the amplifier. Always
disconnect the power cable and antenna before a
storm.
R WARNING! NEVER operate the linear amplifier if
you notice an abnormal odor, sound, or smoke.
Immediately turn OFF the power and remove the power
cable. Contact your Icom dealer or distributor for advice.
R WARNING! NEVER touch the linear amplifier with
wet hands. This may result in an electrical shock or
damage the amplifier.
R WARNING! NEVER let metal, wire, or other objects
contact the linear amplifier inside or make incorrect
contact with connectors on the rear panel. This could
cause an electric shock or damage the amplifier.
R WARNING! NEVER operate the linear amplifier
without solid ground. Always connect the ground wire
to the ground terminal.
R WARNING! NEVER put the linear amplifier on an
unstable place where it may suddenly move or fall.
This could cause an injury or damage the amplifier.
CAUTION: The linear amplifier weighs approximately
21.6 kg (47.6 lb). Always have 2 people carry, lift or
turn over the amplifier.
CAUTION: DO NOT expose the linear amplifier to
rain, snow, or any liquids. They could damage the
amplifier.
CAUTION: DO NOT use or leave the linear amplifier
in excessively dusty environments. This could damage
the amplifier.
CAUTION: DO NOT install or place the linear
amplifier in a place without adequate ventilation or
block any cooling vents on the top, rear, sides, or
bottom of the amplifier. Heat dissipation may be
reduced and damage the amplifier.
CAUTION: DO NOT use harsh solvents such as
Benzine or alcohol to clean the linear amplifier, as
they can damage the amplifier's surfaces. If the
amplifier becomes dusty or dirty, wipe it clean with a
dry, soft cloth.
CAUTION: DO NOT set the connected exciter's
(transceiver's) RF output power to more than the
linear amplifier's maximum input level (200 W).
Otherwise, the amplifier will be damaged.
CAUTION: DO NOT change the internal settings
of the amplifier. This may reduce its performance
and/or cause extensive and expensive damage to
the amplifier. The amplifier warranty does not cover
any problems caused by unauthorized internal
adjustments.
NEVER place the linear amplifier in an insecure place
to avoid inadvertent use by unauthorized persons.
BE CAREFUL! The linear amplifier may become hot
after continuously transmitting for a long period of
time.
NOTE: DO NOT use or leave the linear amplifier in
areas with temperatures below –10°C (+14°F) or
above +40°C (+104°F).
NOTE: During maritime mobile operation, keep the
linear amplifier as far away as possible from the
magnetic navigation compass to prevent erroneous
indications.
Turn OFF the linear amplifier's power and disconnect
the power cable when you will not use the amplifier for
a long period of time.
The LCD display may have cosmetic imperfections
that appear as small dark or light spots. This is not a
malfunction or defect, but a normal characteristic of
LCD displays.
vi