D Connecting 1 Icom And 1 Non-Icom Exciter To [Input 1] And [Input 2]; D Connecting 1 Non-Icom Exciter To [Input 1] - Icom IC-PW2 Instruction Manual

2
INSTALLATION AND CONNECTIONS
Connecting to exciters

D Connecting 1 Icom and 1 non-Icom exciter to [INPUT 1] and [INPUT 2]

REMOTE1
INPUT2 INPUT1
ACC2
IC-PW2
LPin 7: 13.8 V DC
output
ALC2 SEND2
1
* When the relay contact capacity of the SEND line (transmission/reception switching) is less than 5 V DC/20 mA, connect
using an external relay.
To operate the linear amplifier in the Antenna Selector mode with a non-Icom exciter, supply 13.8 V DC to [ACC 2] using a
2
*
DIN connector.
L The antenna connector must be switched to the one used for each frequency band by pushing

D Connecting 1 non-Icom exciter to [INPUT 1]

Supplied coaxial cable
INPUT1
LPin 7: 13.8 V DC output
IC-PW2 ALC1
1
* When the relay contact capacity of the SEND line (transmission/reception switching) is less than 5 V DC/20 mA, connect
using an external relay.
To operate the linear amplifier in the Antenna Selector mode with a non-Icom exciter, supply 13.8 V DC to [ACC 1] using a
2
*
DIN connector.
L The antenna connector must be switched to the one used for each frequency band by pushing
Coaxial cable (User supplied)
Supplied accessory cable
Supplied remote control cable
ACC1
2
*
RCA plug
1
*
Relay
2
ACC1 *
ANT
SEND1
RCA plug
1
*
To antenna
ANT1
GND
ANT
Ground
SEND
SEND
DC power
ALC
To antenna
ANT
GND
Ground
SEND
SEND
DC power
Relay
ALC
2-7
Supplied coaxial cable
ACC(2)
REMOTE
IC-7610 GND
RF OUT
DC
SEND ALC
power
Non-Icom exciter
(100 W type)
. (p. 4-3)
ANT
Non-Icom exciter (100 W type)
RF OUT
DC
SEND power ALC
. (p. 4-3)
ANT
ANT 1 or
ANT 2
GND
GND