Federal Communications Commission Interference Statement; Industry Canada Statement; Règlement D'industry Canada - Linksys RTP300 - Broadband Router With 2 Phone Ports Administration Manual

Regulatory Information
This appendix includes the following regulatory statements:
• "Federal Communications Commission Interference Statement, " on page 180
• "Industry Canada Statement, " on page 180
• "Règlement d'Industry Canada, " on page 180
• "EC Declaration of Conformity (Europe), " on page 181
• "User Information for Consumer Products Covered by EU Directive 2002/96/EC on Waste
Electric and Electronic Equipment (WEEE), " on page 181
Federal Communications Commission Interference
Statement
This product has been tested and complies with the specifications for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used according to the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which is found by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment or devices
• Connect the equipment to an outlet other than the receiver's
• Consult a dealer or an experienced radio/TV technician for assistance

Industry Canada Statement

This device complies with Industry Canada ICES-003 rule.
Operation is subject to the following two conditions:
This device may not cause interference and
This device must accept any interference, including interference that may cause undesired operation of
the device.
Règlement d'Industry Canada
Cet appareil est conforme à la norme NMB003 d'Industrie Canada.
Le fonctionnement est soumis aux conditions suivantes :
Linksys ATA Administration Guide

Federal Communications Commission Interference Statement

180