Call Forward Settings Section; Selective Call Forward Settings Section - Linksys RTP300 - Broadband Router With 2 Phone Ports Administration Manual

Voice tab > User page >

Call Forward Settings section

Field Description
Cfwd All Dest Forward number for Call Forward All Service
In addition to normal call forward destination as used in the other ATAs, on
the SPA3102 or AG310, you can specify the following additional parameters:
gw0 – forward the caller to use the PSTN gateway
<pstn-number>@gw0 – forward to caller to the PSTN number (dialed
automatically by the SPlocalA through the PSTN gateway)
The default is blank.
Cfwd Busy Dest Forward number for Call Forward Busy Service. Same as Cfwd All Dest.
The default is blank.
Cfwd No Ans Dest Forward number for Call Forward No Answer Service. Same as Cfwd All Dest.
In addition to normal call forward destination as used in the other ATAs, on
the SPA3102 or AG310, you can specify the following additional parameters:
gw0 – forward the caller to use the PSTN gateway
<pstn-number>@gw0 – forward to caller to the PSTN number (dialed
automatically by the SPA through the PSTN gateway)
The default is blank.
Cfwd No Ans Delay Delay in sec before Call Forward No Answer triggers. Same as Cfwd All Dest.
The default is 20.
Voice tab > User page >

Selective Call Forward Settings section

Field Description
Cfwd Sel1- 8 Caller Caller number pattern to trigger Call Forward Selective 1, 2, 3, 4, 5, 6, 7, or 8.
The default is blank.
Cfwd Sel1 - 8 Dest Forward number for Call Forward Selective 1, 2, 3, 4, 5, 6, 7, or 8.
Same as Cfwd All Dest.
The default is blank.
Block Last Caller ID of caller blocked via the Block Last Caller service.
The default is blank.
Accept Last Caller ID of caller accepted via the Accept Last Caller service.
The default is blank.
Cfwd Last Caller The Caller number that is actively forwarded to Cfwd Last Dest by using the
Call Forward Last activation code
The default is blank.
Cfwd Last Dest Forward number for the Cfwd Last Caller parameter.
Same as Cfwd All Dest.
The default is blank.
Linksys ATA Administration Guide
User page
157