Response Status Code Handling Section; Rtp Parameters Section - Linksys RTP300 - Broadband Router With 2 Phone Ports Administration Manual

Voice tab > SIP page >

Response Status Code Handling section

Field Description
SIT1 RSC SIP response status code for the appropriate Special Information Tone (SIT).
For example, if you set the SIT1 RSC to 404, when the user makes a call and a
failure code of 404 is returned, the SIT1 tone is played. Reorder or Busy tone
is played by default for all unsuccessful response status code for SIT 1 RSC
through SIT 4 RSC.
SIT2 RSC SIP response status code to INVITE on which to play the SIT2 Tone.
SIT3 RSC SIP response status code to INVITE on which to play the SIT3 Tone.
SIT4 RSC SIP response status code to INVITE on which to play the SIT4 Tone.
Try Backup RSC SIP response code that retries a backup server for the current request.
Retry Reg RSC Interval to wait before the ATA device retries registration after failing during
the last registration.
The default is 30.
Voice tab > SIP page >

RTP Parameters section

Field Description
RTP Port Min Minimum port number for RTP transmission and reception. The RTP
Port Min and RTP Port Max parameters should define a range that
contains at least 4 even number ports, such as 100 – 106.
The default is 16384.
RTP Port Max Maximum port number for RTP transmission and reception.
The default is 16482.
RTP Packet Size Packet size in seconds, which can range from 0.01 to 0.16. Valid values must
be a multiple of 0.01 seconds.
The default is 0.030.
Max RTP ICMP Err Number of successive ICMP errors allowed when transmitting RTP packets to
the peer before the ATA device terminates the call. If value is set to 0, the ATA
device ignores the limit on ICMP errors.
The default is 0.
Linksys ATA Administration Guide
SIP page
105