Ring Settings Section; Fxo (Pstn) Timer Values (Sec) Section - Linksys RTP300 - Broadband Router With 2 Phone Ports Administration Manual

Field Description
VoIP User 1/2/3/4/5/6/7/ The first of 8 user-id's that a VoIP Caller can use to authenticate itself to the
8 Auth ID SPA using the HTTP Digest method (in other words, by embedding an
Authorization header in the SIP INVITE message sent to the SPA. If the
credentials are missing or incorrect, the SPA will challenge the caller with a
401 response). The VoIP caller whose authentication user-id equals to this ID
is referred to VoIP User 1 of this SPA.
Note: If the caller specifies an authentication user-id that does not match any
of the VoIP User Auth ID's, the INVITE will be rejected with a 403 response.
The default is blank.
VoIP User 1/2/3/4/5/6/7/ Index of the dial plan in the dial plan pool to be used with VoIP User 1.
8 DP
The default is 1.
VoIP User 1/2/3/4/5/6/7/ The password to be used with VoIP User 1. The user assumes the identity of
8 Password VoIP User 1 must therefore compute the credentials using this password, or
the INVITE will be challenged with a 401 response
The default is blank.
Voice tab > PSTN Line page >

Ring Settings section

Field Description
Default Ring 1-8, Follow Line Cfg
Voice tab > PSTN Line page >

FXO (PSTN) Timer Values (sec) section

Field Description
VoIP Answer Delay Delay in seconds before auto-answering inbound VoIP calls for the FXO
account. The range is 0-255.
The default is 3.
PSTN Answer Delay Delay in seconds before auto-answering inbound PSTN calls after the PSTN
starts ringing. The range is 0-255.
The default is 16.
VoIP PIN Digit Timeout
Timeout to wait for the 1
range is 0-255.
The default is 10.
PSTN PIN Digit Timeout to wait for the 1
Timeout
range is 0-255.
The default is 10.
Linksys ATA Administration Guide
PSTN Line page (AG310 and SPA3102)
st
or subsequent PIN digits from a VoIP caller. The
st or subsequent PIN digits from a PSTN caller. The
151