Speed Dial Settings Section; Supplementary Service Settings Section - Linksys RTP300 - Broadband Router With 2 Phone Ports Administration Manual

Voice tab > User page >

Speed Dial Settings section

This section does not apply to the WIP310 wireless phone.
Field Description
Speed Dial 2-9 Target phone number (or URL) assigned to speed dial 2, 3, 4, 5, 6, 7, 8, or 9.
The default is blank.
Voice tab > User page >

Supplementary Service Settings section

The ATA device provides native support of a large set of enhanced or supplementary services.
All of these services are optional. The parameters listed in the following table are used to
enable or disable a specific supplementary service. A supplementary service should be
disabled if a) the user has not subscribed for it, or b) the Service Provider intends to support
similar service using other means than relying on the ATA device.
Field Description
CW Setting Call Waiting on/off for all calls.
The default is yes.
Block CID Setting Block Caller ID on/off for all calls.
The default is no.
Block ANC Setting Block Anonymous Calls on or off.
The default is no.
DND Setting DND on or off.
The default is no.
CID Setting Caller ID Generation on or off.
The default is yes.
CWCID Setting Call Waiting Caller ID Generation on or off.
The default is yes.
Dist Ring Setting Distinctive Ring on or off.
The default is yes.
Secure Call Setting If yes, all outbound calls are secure calls by default.
The default is no.
Message Waiting This value is updated when there is voice mail notification received by the
ATA device. The user can also manually modify it to clear or set the flag.
Setting this value to yes can activate stutter tone and VMWI signal. This
parameter is stored in long term memory and will survive after reboot or
power cycle.
The default is no.
Linksys ATA Administration Guide
User page
158