Basic Installation And Configuration" Section; Upgrading The Firmware For The Linksys Ata Device - Linksys RTP300 - Broadband Router With 2 Phone Ports Administration Manual

Basic Administration and Configuration of Your Linksys ATA
Basic Installation and Configuration
See your particular Linksys ATA device's Quick Installation Guide and User Guide for
instructions. If you are configuring the complete Linksys Voice System, also refer to the
Installation and Configuration Guide

Upgrading the Firmware for the Linksys ATA Device

In this procedure, you install the firmware files that you downloaded previously.
1. Determine the address of the Linksys ATA device:
a. Connect an analog telephone to the Phone 1 or Phone 2 port on the ATA device.
b. Press **** on the keypad to access the IVR menu.
c. Press 110# to determine the Internet (WAN) IP address.
2. Make a note of the IP address that is announced.
NOTE: If the administration computer is connected to the Ethernet port of the Linksys ATA
device, the default IP address is 192.168.0.1.
3. Use the administration computer to install the latest firmware:
a. Extract the Zip file, and then run the executable file to upgrade the firmware.
b. When the Firmware Upgrade Warning window appears, click Continue.
c. In the next window that appears, enter the IP address of the Linksys ATA device, and
then click OK.
d. In the Confirm Upgrade window, verify that the correct device information and product
number appear. Then click Upgrade.
e. A progress message appears while the upgrade is in progress. The success window
appears when the upgrade is completed. The device reboots.
f. Click OK to close the confirmation message.
g. To verify the upgrade, point the web browser to the IP address of the Linksys ATA device.
Check the Router > Status page. The Software Version field should show the firmware
version that you installed.
NOTE: You may need to refresh your browser to display the updated page reflecting the
new version number.
Linksys ATA Administration Guide
Basic Installation and Configuration
.
LVS
30