Wireless Regulatory Information; Fcc Statement; Fcc Radiation Exposure Statement; Innovation, Science And Economic Development Canada Statement - Linksys MX4300 Regulatory Information

Wireless Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This product has been tested and complies with the
specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used according to the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
is found by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment
and devices
• Connect the equipment to an outlet other than the
receiver's
• Consult a dealer or an experienced radio/TV technician
for assistance
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate this equipment.
2.4GHz operation of this product in the USA is firmware-
limited to channels 1 through 11.
The device for the band 5150-5250 MHz is only for indoor
usage to reduce the potential for harmful interference to
co-channel mobile satellite systems.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance
35 cm between the radiator and your body.
This device and its antennas(s) must not be co-located
or operating in conjunction with any other antenna or
transmitter except in accordance with FCC multi-transmitter
product procedures.
Innovation, Science and Economic Development Canada
Statement
CAN ICES-003(B) / NMB-003(B)
This device complies with ISED's license-exempt RSS
standards. Operation is subject to the following two
conditions: (1) This device may not cause interference,
and (2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Wireless Regulatory Information
For product available in the USA/Canada market, only
channel 1~11 can be operated. Selection of other channels
is not possible.
The device could automatically discontinue transmission in
case of absence of information to transmit, or operational
failure. Note that this is not intended to prohibit transmission
of control or signaling information or the use of repetitive
codes where required by the technology.
Innovation, Science and Economic Development Canada
Radiation Exposure Statement
This equipment complies with ISED radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance
35 cm between the radiator & your body.
This device and its antennas(s) must not be co-located
or operating in conjunction with any other antenna or
transmitter except in accordance with ISED multi-transmitter
product procedures.
Restrictions in the 5 GHz Band
The device for the band 5150-5250 MHz is only for indoor
usage to reduce potential for harmful interference to co-
channel mobile satellite systems.
This device has been designed to operate with an antenna
having a maximum gain of 3.1 dBi and 5.1 dBi at 2.4 GHz
and 5 GHz respectively. Antenna having a higher gain is
strictly prohibited per regulations of ISED. The required
antenna impedance is 50 ohms.
The maximum antenna gain (Please see the table below)
permitted (for devices in the bands 5250-5350 MHz and
5470-5725 MHz) to comply with the EIRP limit and the
maximum antenna gain permitted for devices in the band
5725-5850 MHz shall be such that the equipment still
complies with the EIRP limits specified for point-to-point
and non-point-to-point operation as appropriate because
high power radars are allocated as primary users (meaning
they have priority) in 5250-5350 MHz and 5650-5850 MHz,
these radars could cause interference and/or damage to
license exempt LAN devices. The worst-case tilt angle(s)
necessary to remain compliant with the e.i.r.p. elevation
mask requirement set forth in Section 6.2.2(3) shall be
clearly indicated.
Antenna
For 2.4 GHz
No.
Type Gain (dBi)
1 Dipole 3.1
2 Dipole 2.8
3 Dipole N/A
4 Dipole N/A
5 Dipole N/A
6 Dipole N/A
Antenna
For 5 GHz
Gain (dBi) Connector
5.0 I-PEX (MHF)
5.1 I-PEX (MHF)
3.8 I-PEX (MHF)
4.1 I-PEX (MHF)
4.1 I-PEX (MHF)
3.8 I-PEX (MHF)
1