Table of Contents
Advertisement
Available languages
Available languages
SAFETY
HAZARDS AND SAFETY PROVISIONS DURING ASSEMBLY
When assembling the appliance, watch out for the following hazards and provide for the counter-
measures indicated below:
Source of hazard: Handling of heavy loads
Where or in which situations
Hazard
does the hazard occur?
Risk of injury
• When the appliance moves • Use a suitable lifting de-
due to body
overload
HAZARDS AND SAFETY PROVISIONS DURING INSTALLATION AND
COMMISSIONING, ADJUSTMENTS AND PART REPLACEMENT
During appliance installation, commissioning, adjustment and part replacement procedures,
watch out for the following hazards and provide for the countermeasures indicated below:
► Source of hazard: Appliance mechanics
Hazard
Risk
of
crushing
parts of the body in
case of tip-over or
fall of the appliance
Risk of cutting due
to sharp edges
Risk
of
crushing
parts of the body in
case of fall of the ap-
pliance
3395230_ut_GB_rev.1
Where or in which situations
does the hazard occur?
When the appliance is lifted • Pay attention to the centre
When handling sheet-met-
al parts
In case of uneven or sloped
fl oors
Countermeasures
vice to place the appliance
on the work bench, on the
base
• Adjust the position only if
a suitable number of peo-
ple is available, otherwise
observe the limit values for
lifting and transport
• Comply with the applica-
ble laws on accident pre-
vention for the installation
place
• Wear personal protective
equipment
Countermeasures
of gravity
• Avoid collisions
• Pay special care during this
activity
• Wear personal protective
equipment in accordance
with safety regulations
• Comply with the correct in-
stallation requirements as
per section "Installing the
appliance" on page 10 of
the installation manual.
ENGLISH
Safety device
• P r o t e c t i v e
gloves
• Protective shoes
• Safety
helmet
(e.g.
for
sus-
pended
loads,
overhead opera-
tions...)
Safety
device
None
None
None
5
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the 0S1PE4C and is the answer not in the manual?