Chapter 4: Performing Advanced Configuration
In This Chapter
Configuring the AP Using the HTTP/HTTPS Interface
●
System Configuration
●
such as system name.
Network Configuration
●
DHCP server, and Link Integrity.
Interface Configuration
●
- Configure the Access Point's interfaces: Wireless and Ethernet.
- Configure a Wireless Distribution System (WDS).
Management Configuration
●
- Configure the Access Point's management Passwords, IP Access Table, and Services
such as configuring secure or restricted access to the AP via SNMPv3, HTTPS, or CLI.
- Configure Secure Management, SSL, Secure Shell (SSH), and RADIUS-Based Access
Management.
- Set up Automatic Configuration for Static IP.
Filtering Configuration
●
Static MAC Address filters, Advanced filters, and Port filters.
Alarm Configuration
●
Groups, the Alarm Host Table, and the Syslog features.
Bridge Configuration
●
Protocol, Storm Threshold protection, Intra BSS traffic, and Packet Forwarding.
RADIUS Profile Configuration
●
such as RADIUS Access Control and Accounting.
Security Configuration
●
- Configure security features such as MAC Access Control, WPA, WEP Encryption, and
802.1x.
- Configure Rogue Access Point Detection (RAD) and define the Scan Interval.
- Configure up to 16 VLAN and SSID pairs, and assign Security and RADIUS Profiles for
each pair.
on page 64: Describes how to configure specific system information
on page 65: Describes how to configure IP settings, DNS client,
on page 72: Describes how to:
on page 92: Describes how to:
on page 110: Describes how to configure Ethernet Protocol filters,
on page 117: Describes how to configure the Alarm (SNMP Trap)
on page 130: Describes how to configure the Spanning Tree
on page 133: Describes how to configure RADIUS features
on page 140: Describes how to:
on page 62
Issue 1 October 2004
61