Spectralink Voip Commands; Spectralink Voip Parameters (802.11B And B/G Modes Only) - Avaya AP-3 User Manual

Table 90: Spanning Tree Priority and Path Cost Table Parameters 2 of 2
Name
State
Status

SpectraLink VoIP Commands

SpectraLink VoIP Parameters (802.11b and b/g Modes Only)

These parameters enable or disable the SpectraLink Voice over IP feature.
The Spectralink Legacy Support parameter should be enabled if the AP is operating in 802.11bg
mode and legacy 802.11 Spectralink telephones are used. This parameter will set the basic
rates of the AP to be 1 and 2 Mbps in 802.11bg mode and will allow old telephones that operate
only at the 1 and 2 Mbps basic rate to connect to the AP.
Table 91: SpectraLink VoIP Parameters
Name
Spectralink VoIP
Spectralink VoIP Status
Spectralink Legacy Support
Type Values
Integer disable
blocking
listening
learning
forwarding
broken
Integer enable
disable
Type Values
Group N/A
Integer enable
disable
(default)
Integer enable
disable
(default)
SpectraLink VoIP Commands
Access CLI Parameter
R state
RW status
Access CLI Parameter
R spectralink
RW speclinkstatus
RW speclinklegacysupport
Issue 1 October 2004
2 of 2
275