Note:
The TFTP Server IP Address and Image File Name fields are only available if
Note:
ScanTool detects that the AP does not have a valid software image installed. See
Client Connection Problems
h. Click OK to save your changes.
Result: The Access Point will reboot automatically and any changes you made will
take effect.
i. When prompted, click OK a second time to return to the Scan List screen.
j. Click Cancel to close the ScanTool.
k. Proceed to Setup Wizard for information on how to access the HTTP interface.
Setup Wizard
The first time you connect to an AP's HTTP interface, the Setup Wizard launches automatically.
The Setup Wizard provides step-by-step instructions for how to configure the Access Point's
basic operating parameter, such as Network Name, IP parameters, system parameters, and
management passwords.
Setup Wizard Instructions
Follow these steps to access the Access Point's HTTP interface and launch the Setup Wizard:
1. Open a Web browser on a network computer. The HTTP interface supports the following
Web browser:
Microsoft Internet Explorer 6 with Service Pack 1 or later
●
Netscape 6.1 or later
●
2. If necessary, disable the browser's Internet proxy settings. For Internet Explorer users,
follow these steps:
a. Select Tools > Internet Options.
b. Click the Connections tab.
c. Click LAN Settings.
d. If necessary, remove the check mark from the Use a proxy server box.
e. Click OK twice to save your changes and return to Internet Explorer.
on page 198.
Initialization
Issue 1 October 2004
43