Search; Example; Set; Syntax - Avaya AP-3 User Manual

The Command Line Interface

search

Lists the parameters supported by the specified table. This list corresponds to the table
information displayed in the HTTP interface. In the following example, the CLI returns the list of
parameters that make up an entry in the IP Access Table.

Example

[Device-Name]> search mgmtipaccesstbl
Figure 83: Results of "search mgmtipaccesstbl" CLI command

set

Configures the value of the specified parameter. To see a definition and syntax example, type
only set and then press the Enter key. To see a list of available parameters, enter a space, then
a question mark (?) after set (example: set?).
As shown in the following examples, parameters may be set individually or all parameters for a
given table can be set with a single statement.

Syntax

[Device-Name]> set <parameter> <value>
[Device-Name]> set <table> <index> <argument 1> <value 1> ... <argument N> <value
N>

Configuring Objects that Require Reboot

Certain objects supported by the Access Point require a device reboot for the changes to take
effect. To inform you of this behavior, the CLI provides informational messages when you have
configured an object that requires a reboot. The following messages are displayed as a result of
the configuring such object or objects.
230 Wireless AP-3 User's Guide