Enable/Disable Interference Robustness (802.11B Only); Enable/Disable Load Balancing (802.11B Only); Enable/Disable Medium Density Distribution (802.11B Only); Set The Distance Between Aps (802.11B Only) - Avaya AP-3 User Manual

The Command Line Interface

Enable/Disable Interference Robustness (802.11b Only)

[Device-Name]> set wif <index> interrobust <enable/disable>

Enable/Disable Load Balancing (802.11b Only)

[Device-Name]> set wif <index> ldbalance <enable/disable>

Enable/Disable Medium Density Distribution (802.11b Only)

[Device-Name]> set wif <index> meddendistrib <enable/disable>

Set the Distance Between APs (802.11b Only)

[Device-Name]> set wif <index> distaps <large, medium, small, minicell, microcell>
[Device-Name]> reboot 0
Note:
The distance between APs should not be approximated. It is calculated by means
Note:
of a manual Site Survey, in which an AP is set up and clients are tested
throughout the area to determine signal strength and coverage, and local limits
such as physical interference are investigated. From these measurements the
appropriate cell size and density is determined, and the optimum distance
between APs is calculated to suit your particular business requirements.

Set the Multicast Rate (802.11b Only)

[Device-Name]> set wif <index> multrate <1,2,5.5,11 (Mbits/sec)>
Note:
The Distance Between APs must be set before the Multicast Rate.
Note:
Note:
There is an inter-dependent relationship between the Distance between APs and
Note:
the Multicast Rate. In general, larger systems operate at lower average transmit
rates.
Table 108: Distance between APs and Multicast Rates 1 of 2
Distance between APs
Large
Medium
294 Wireless AP-3 User's Guide
SeeTable 108.
Multicast Rate
1 and 2 Mbits/sec
1, 2, and 5.5 Mbits/sec