Hardware Installation
AP-3 with Active Ethernet
●
AP-3 with Power Supply
●
5 GHz or AP-3 11a Upgrade Kit
●
AP-3 with Active Ethernet
Follow these steps for AP-3 with Active Ethernet:
1. Slide the AP module onto the mounting bracket. Make sure it is properly seated. See
Figure
2.
Figure 2: Insert Module into Mounting Bracket
2. Slide an 802.11b, 802.11b/g wireless card, or 802.11a card with antenna adapter (not
included in the kit) into Slot A or B. If you are using two wireless cards, repeat this step for
the second card. See
Note:
The 802.11a wireless card with antenna adapter will only fit in Slot A.
Note:
on page 31
on page 33
on page 37
Figure
3.
Hardware Installation
Issue 1 October 2004
31