American Dynamics EDVR Installation And Operation Manual page 73

3. Set up a schedule to start recording only during the scheduled time period and when sensor alarms are
triggered.
Note
On Alarm Input Link, Sensor and Video Loss are defaulted to On for all cameras so you do not have to
change the Alarm Input Link settings. If you have turned any of them Off, then you need to turn them back on
if desired. For the turn-on procedure, see example 4 on motion alarm, the Input Link of which is defaulted to
Off for all cameras.
Schedule Settings
Enable
1 Schedule1
2 Schedule2 Disable Enter
3 Schedule3 Disable Enter
4 Schedule4 Disable Enter
5 Schedule5 Disable Enter
6 Schedule6 Disable Enter
7 Schedule7 Disable Enter
8 Schedule8 Disable Enter
Return
menu: exit
enter: select
shuttle: value
 / : item
Schedule Settings
1 Date
2 Start Time
3 End Time
4 Start Record
5 Alarm Settings
6 Record Settings
7 Motion Settings
Return
menu: exit
enter: select
shuttle: value
 / : item
Enter
Everyday
14:00 PM
18:00 PM
No
Enable
Enter
Disable Enter
Disable Enter
Schedule Settings
1 Date
2 Start Time
3 End Time
4 Start Record
5 Alarm Settings
>
6 Record Settings
7 Motion Settings
Return
menu: exit
enter: select
shuttle: value
 / : item
Alarm Settings
1 Alarm Duration
2 Pre-Alarm
3 Alarm Record Rate
4 Alarm Record Mode
5 Alarm Record Quality
6 Alarm Input Link
>
7 Alarm Out Link
Return
menu: exit
enter: select
shuttle: value
 / : item
Configuration Menus
Everyday
14:00 PM
18:00 PM
No
Enable
Enter
Disable Enter
Disable Enter
30 SEC
On
60
F/S
Enter
Enter
Enter
Enter
63