Appendix E: Using Cds - American Dynamics EDVR Installation And Operation Manual

When using CD-ROM, CD-R, or CD-RW media, do not write on or stick anything to either side of the disk as
doing so could cause an error in recording (that is, the data on the disk may be damaged).
Inserting a Disk in the Drive
1. Press the eject button.
2. Place the disk in the tray (caddy) as illustrated in the following.
Notes

Inset the disk so that the printed (label) side is up.

When using a 12 cm disk, place it in the center of the tray (caddy) where you see the indication
(recess) for the larger position. When using an 8 cm disk, place it in the center of the caddy where
you can see the indication (recess) for the 8 cm disk.

Never place two disks in the caddy at the same time.
3. Do not touch the recording surface of the disk.
4. To insert a disk into or remove a disk from the caddy, press the eject button to open the caddy; press the
eject button a second time to close the caddy.
Ejecting a Disk from the Drive
1. Press the eject button.
2. Carefully lift out the disk.
3. Press the eject button a second time to close the tray.
Caution
After the tray has been ejected and the disk has been retrieved from the caddy or placed in the caddy, be
sure to close the tray to avoid the accumulation of dust or other foreign debris inside the caddy. Not taking
such a precaution can cause the pick up head to accumulate dust, and it may become unreliable in reading or
writing data.

Appendix E: Using CDs

>
108