American Dynamics EDVR Installation And Operation Manual page 62

EDVR Installation and Operation Guide
5. Size
Determines the size of the targets that you will detect, ranging from 1H1W to 9H9W.
H indicates height and W indicates width. If you select a relatively large height or width, the EDVR will not be
triggered by a very small object.
Return
Go back to the previous page.
Set Up Basic Motion Detection Recording
You need to first configure the alarm settings to activate the alarms. Do not configure the motion settings until you
are comfortable with all of the other parameters in these settings. You can set up motion detection without
modifying the other motion settings.
Turn on Motion mode in Alarm Input Link
1. Press the MENU button to enter the Main Menu.
2. Select item 6 Advanced Settings and press the ENTER button.
3. Select item 1 Alarm Settings and press the ENTER button.
4. Select item 8 Alarm Input and press the ENTER button.
5. Select the channel for motion detection, press the Right () button twice to Motion column, and set the mode
to On using the shuttle ring.
6. Repeat the previous steps for each of the channels that you want to activate with motion detection.
7. Press the MENU button to return to the Alarm Settings menu.
Turn on Start Record mode in Alarm Out Link
1. Select item 9 Alarm Out Link and press the ENTER button.
2. Select item 7 Start Record, press the Right () button twice to go to the Motion column, and set the mode to
Yes with the shuttle ring.
Save settings to complete this process
1. Press the MENU button four times to go to the Main Menu. The cursor should be at the menu item, Exit
Menu.
2. Press the ENTER button to exit.
3. Press ENTER again to save the changes.
Set Up Advanced Motion Detection Recording
Adjust Target Zone for limited motion detection area
1. Press the MENU button to enter Main Menu.
2. Select item 6 Advanced Settings and press the ENTER button.
3. Select item 3 Motion Settings and press the ENTER button.
4. Select the channel to set and press the ENTER button. You should see a rectangle in the lower right corner
marked with dots. Dots indicate that the area is enabled for motion detection.
While pressing the CALL button, press the Left/Right (, ) buttons to control cursor A.
5.
While pressing the SEQ button, press the Left/Right (, ) buttons to control cursor B.
6.
While pressing the CALL button, press the Up/Down (, ) buttons to control cursor A.
7.
While pressing the SEQ button, press the Up/Down (, ) buttons to control cursor B.
8.
52 EDVR