Covert Camera - American Dynamics EDVR Installation And Operation Manual

9. Shrink the rectangle to cover the area you want to enable or disable for motion detection.
10. Press the ENTER button to toggle the dots to x's. The area in the rectangle is now disabled.
11. Repeat the previous steps for each area you want to enable/disable.
Notes

Each press of the ENTER button will cycle each area through three modes: enable, disable, toggle. (All
enabled sub-areas will be disabled and disabled sub-areas will become enabled.)

Press the MENU button, then ENTER to view what has been set.

This procedure can be applied to each dot if needed.
Target Zone
The Manual setting allows you to set up each area as described in the preceding steps.
The Automatic setting would allow the system to detect motion and enable the detected motion area. To become
familiar with this setting (while viewing this menu), place a camera next to the EDVR. Disable the whole area, and
then move your hand in front of the camera. All detected motion will enable the dots.
Track Detect
Use the shuttle ring to adjust values to Up, Down, Left, or Right to indicate which direction of motion you want to
track. For example, in a grocery store, if you want to start recording when someone comes in but not record his
exit, set Track Detect to Up if the camera is facing the door which is on the top of the screen.

Covert Camera

Enter the following menu and set each channel (camera) to On for hidden or deactivate to Off for exposed
recording, respectively.
Advanced Settings
1 Alarm Settings
2 Record Settings
3 Motion Settings
4 Camera Covert
5 Operation Locks
6 Communication
7 Disk Setup
8 Schedule
9 Dome Settings
Return
menu: exit
enter: select
/: item
Note
For the Camera Covert menu: Items CAM5 through CAM9 are for the 9CH and 16CH EDVRs only, and items
CAM10 through CAM16 are only for the 16CH EDVR.
Enter
Enter
Enter
Enter
Enter
>
Enter
Enter
Enter
Enter
Camera Covert
CAM1 On
menu: exit
CAM2 Off
shuttle: value
▲/▼: item
CAM3 Off
CAM4 Off
CAM5 Off
CAM6 Off
CAM7 Off
CAM8 Off
CAM9 Off
CAM10 Off
CAM11 Off
CAM12 Off
CAM13 Off
CAM14 Off
CAM15 Off
CAM16 Off
Return
Configuration Menus
53