MAGSTIM The Rapid2 Operating Manual page 82

5.10.3. Recall A File
• On the file maintenance screen
dial and press 'View'
screen.
• Press 'Repetitive'
• Press 'Run Session'
5.10.4. Change A Saved Protocol
• On the file maintenance screen
dial and press 'Open'
the screen.
• Press 'Back'
• From the 'Options Menu' select 'Repetitive Mode'
set on the screen.
• Make the desired changes by selecting each window and using the control
dial.
• Your changes will be automatically saved on the open file.
Note: When a file is 'Open', any changes made will be automatically saved.
When a file is 'Viewed' changes are not saved automatically but can be saved by
pressing ''Save Session'
to overwrite the file, select 'YES' to save the changes.
5.10.5. Patient Details
If necessary patient details can be
associated with a protocol. As files
are not encrypted, we recommend
you do not
Identifiable Data (PID) on the UI
or in exported files. Should you
store PID it is your responsibility
to ensure compliance with the
relevant regulations
protection.
• On the file maintenance screen
(Figure 5.18), select or create a
file (see "5.10.1. File Selection" and
"5.10.2. Saving A Protocol" on page
75).
The Magstim ® Company Ltd.
. The file name will be shown in the top right of the
, your protocol should be set on the screen.
to run your protocol.
. The file name will be shown in the top right of
.
and then 'Save as'
store Personally
on data
(Figure 5.73), select the file using the control
(Figure 5.17), select the file using the control
, a prompt will ask if you wish
Figure 5.18: Patient details window
MOP16-EN-02
, your protocol should be
76