System Start-Up - MAGSTIM The Rapid2 Operating Manual

3.4 System Start-up

a.
Mains Power
Switch
Resume
Figure 3.9: Stimulator overview
• Ensure the stimulator is fully connected and the mains power switch
3.9, a) is set to on (I) (the green power indicator should flash if the switch is on).
• Press the on button
• After a few seconds the welcome screen will appear on the UI screen.
• Press continue
Note: It may take a few extra moments before repetitive mode is available.
For more information on the options menu see page 60.
Note: For first time use it is recommended to set the system parameters such as
the time, date and preference options. From the options menu select 'System',
then 'User Configuration' and refer to "5.8 User Configuration" on page 74.
The Magstim ® Company Ltd.
b.
On Button
c.
Coil Connector
h.
Touch Screen Button
(Figure 3.9,
to advance to the options menu.
Frequency
i.
Touch Screen Window
10.0
Hz
b) to initialize the system.
MOP16-EN-02
d.
Run Button
e.
Trigger Button
f.
Stop Button
g.
Control Dial
(Figure
40