Omron CP1L CPU UNIT - 06-2007 Operation Manual page 617

Connections to Serial Communications Option Boards
Connection Examples
The connection examples in the remainder of this section show only the basic connection diagrams. We rec-
ommend that appropriate noise countermeasures be taken in actual applications, including the use of shielded
twisted-pair cables. Refer to Recommended RS-422A/485 Wiring Examples on page 601 for actual wiring
methods.
Host Computer Connections
1:1 Connections Using RS-232C Ports
• IBM PC/AT or Compatible Computers
CPU Unit
Signal Pin
RS-232C
Option
Board
D-sub, 9-pin
connector (male)
• Using NT-AL001-E Converting Link Adapters
Computer
Shield
Pin
Signal
RS-232C
RS-232C
Interface
D-sub, 9-pin
connector (male)
5-V (+)
power (-)
Note We recommend using the following NT-AL001-E Link Adapter Connecting Cables to connect to NT-
AL001-E Link Adapters.
XW2Z-070T-1: 0.7 m
XW2Z-200T-1: 2 m
!Caution Do not use the 5-V power from pin 6 of the RS-232C Option Board for anything but the NT-
AL001-E Link Adapter. Using this power supply for any other external device may damage the
RS-232C Option Board or the external device.
584
Computer
Pin Signal
D-sub, 9-pin
connector (female)
NT-AL001-E Link Adapter
Signal Signal Pin
RS-422A
Terminal block
D-sub, 9-pin
connector (male)
DIP Switch Settings
Pin 1: ON
Pin 2: ON
(terminating resistance)
Pin 3: OFF
Pin 4: OFF
Pin 5: OFF
Pin 6: OFF
RS-
232C
interface
NT-AL001-E Link Adapter
Pin Signal Pin
Signal
RS-232C
(See note)
D-sub, 9-pin
connector (male)
DIP Switch Settings
Pin 1: ON
Pin 2: ON
(terminating resistance)
Pin 3: OFF
Pin 4: OFF
Pin 5: OFF
Pin 6: ON
Appendix F
CPU Unit
Pin Signal
RS-232C
Option
Board
D-sub, 9-pin
connector (male)