Message Read: 09 20 - Omron CJ - REFERENCE MANUAL 07-2009 Reference Manual

FINS Commands
Comments

5-3-21 MESSAGE READ: 09 20

Execution Conditions
Command Format
Response Format
Parameters
198
Day of week: As follows:
Value (hex) 00
Day of week Sun
End code (response)
Refer to 5-1-3 End Codes for information on end codes.
If the second and the day of week are not specified, 00 (BCD) will be set as
the second and the previous value will be kept for the day.
If the second is specified, but the day of week is omitted, the previous setting
will not be changed.
The PLC does not check the day of week from the day of month. This means
that no error will occur even if the day of month and the day of week do not
agree.
The PLC automatically checks the range of the specified data. If any portion
of the data is incorrect, the clock will not be set.
Reads messages generated by MSG(195).
Access right at
other device
OK
RUN mode
OK
09 20
Command Message No.
code parameter
09 20
Command End code Message No.
code parameter
Message number parameter (command and response)
In the command format, turn ON (1) the bits of the messages to be read. In
the response format, the bits of the messages being returned will be ON (1). If
no bits are turned ON in the command format, all bits will be OFF (0) in the
response format and no further data will be returned.
01 02 03
Mon Tues Wed
UM read DIP switch UM write
protection protection
OK OK
MONITOR mode
OK
32 bytes
Message
Section 5-3
04 05 06
Thur Fri Sat
Network write
protection
OK
PROGRAM mode
OK
32 bytes
Message