Omron CJ - REFERENCE MANUAL 07-2009 Reference Manual page 209

FINS Commands
Command Format
Response Format
Parameters
Comments
03 08 FF
Command Program
code No.
03 08
Command End code
code
Program No. (command)
Set to FFFF (hex).
Clear code (command)
Without interrupt tasks: 00 (hex)
With interrupt tasks:
End code (response)
Refer to 5-1-3 End Codes for information on end codes.
The program area can be cleared even if it is read-protected from a Program-
ming Device. When the program area is cleared, protection will also be
cleared.
Without Interrupt Tasks
In this mode, only one single cyclic task 0 is set up.
Name
Power interrupt task
Scheduled interrupt task
I/O interrupt task
Cyclic task
With Interrupt Tasks
In this mode, one single cyclic task 0 and one or several interrupt tasks are set
up.
Name
Power interrupt task
Scheduled interrupt task
I/O interrupt task
Cyclic task
Note Interrupt tasks and cyclic tasks contain only one END(001) instruction after
execution.
When the "Prohibit from overwriting to a protected program" setting is
enabled, this command cannot be executed.
FF
Clear code
10 (hex)
Number
0
0
0
1
Number
1
2
32
1
Section 5-3
Task No.
---
---
---
0
Task No.
1
2
3
100
.
.
131
0
187