Forced Set/Reset Cancel - - Kc - Omron CJ - REFERENCE MANUAL 07-2009 Reference Manual

C-mode Command Details
4-3-29 FORCED SET/RESET CANCEL – – KC
Command Format
Response Format
Execution Conditions
Commands
Single Multiple
OK No
End Codes
140
will also be returned if the a data specification of 0 or 1 is used when a timer
or counter is designated.
End code (Hex)
00
01
13
14
15
18
21
Cancels all forced set and forced reset bits (including those set by FORCED
SET, FORCED RESET, and MULTIPLE FORCED SET/RESET).
@
Unit No. (BCD)
Responses
Single Multiple RUN
OK No No
An end code of 14 (format error) will be returned if the length of the command
is incorrect. (The forced set/reset/cancel data can be 16 bytes long.)
End code (Hex)
00
01
13
14
15
18
21
Normal completion
Not executable in RUN mode
FCS error
Format error
Entry number data error
Frame length error
Not executable due to CPU Unit CPU error.
1 0
@ K C
x 10 x 10
Unit No. (BCD) Header
code
1 0
K C
x 10 x 10 x 16
Header End code
code
PLC Mode
MON PROG
OK OK
Normal completion
Not executable in RUN mode
FCS error
Format error
Entry number data error
Frame length error
Not executable due to CPU Unit CPU error.
Section 4-3
Contents
* ↵
FCS Terminator
* ↵
1 0
x 16
FCS Terminator
UM Area
Write-protected Read-protected
OK
Contents
OK