File Copy: 22 07 - Omron CJ - REFERENCE MANUAL 07-2009 Reference Manual

FINS Commands
Command Format
22 05
Command Disk No.
code
Response Format
Parameters
Comments

5-3-37 FILE COPY: 22 07

Execution Conditions
218
12 bytes
No. of File name
files
22 05
Command End code
code
Disk number (command)
The classification of the file memory with the file to be deleted is specified as
follows:
8000 (hex): Memory card
8001 (hex): EM file memory
Number of files (command)
Specify the number of files to be deleted.
File name (command)
Specify the name of the file to be deleted. For details on the configuration,
refer to page 168.
Directory length
Indicates the length of the absolute directory path. The maximum number of
characters is 65. To specify the root directory as the absolute directory path,
specify 0000 (hex) as the directory length.
Absolute directory path
Indicates the absolute path from the root directory. It begins with \ (5C hex),
and the drive name and colon (:) are not required. "\" is used to delimit the
lower directory. It is not required at the end of the final absolute path. No set-
ting is required to specify the root directory itself.
Number of files (response)
Indicates the number of files actually deleted.
End code (response)
Refer to 5-1-3 End Codes for information on end codes.
The specified files will be deleted in sequence. If non-existing file names have
been specified, the PLC will ignore them and the operation will continue.
Copies a file from one file memory to another file memory connected to the
same CPU Unit.
Access right at
other device
No
RUN mode
OK
12 bytes
File name Directory
length
No. of
files
UM read DIP switch UM write
protection protection
OK
MONITOR mode
OK
Section 5-3
Absolute directory
path
Network write
protection
OK No
PROGRAM mode
OK