I/O Table Generate - - Mi - Omron CJ - REFERENCE MANUAL 07-2009 Reference Manual

C-mode Command Details
End Codes
4-3-34 I/O TABLE GENERATE – – MI
Command Format
Response Format
Limitations
Execution Conditions
Commands
Single Multiple
OK No
End Codes
144
An end code of 14 (format error) will be returned if the length of the command
is incorrect (the total size of the program is not a multiple of 8 bytes) or the first
frame contains no program data.
An end code of 15 (entry number data error) will be returned if the specified
write data is not hexadecimal.
End code (Hex)
00
01
02
13
14
15
18
19
21
23
A3
A4
A5
A8
Corrects the registered I/O table to match the actual I/O table.
@
Unit No. (BCD)
The UM write-protected end code for this command is different from that of
the other commands.
Responses
Single Multiple RUN
OK No No
An end code of 14 (format error) will be returned if the length of the command
is incorrect.
End code (Hex)
00
01
02
03
13
Normal completion
Not executable in RUN mode
Not executable in MONITOR mode
FCS error
Format error
Entry number data error
Frame length error
Not executable
Not executable due to CPU Unit CPU error.
User memory protected
Aborted due to FCS error in transmit data
Aborted due to format error in transmit data
Aborted due to entry number data error in transmit data
Aborted due to frame length error in transmit data
@ 1 0 M I
x 10 x 10
Header
Unit No. (BCD)
code
1 0
M I
x 10 x 10 x 16
Header End code
code
PLC Mode
MON PROG
No OK
Normal completion
Not executable in RUN mode
Not executable in MONITOR mode
UM write-protected
FCS error
Section 4-3
Contents
* ↵
FCS Terminator
* ↵
1 0
x 16
FCS Terminator
UM Area
Write-protected Read-protected
No
Contents
OK