Omron CJ - REFERENCE MANUAL 07-2009 Reference Manual page 119

Communications Frames
ASCII) + text (2
using ASCII.
Note Set the contents of S+3 when using CompoWay/F commands as follows:
Set the SID "0" as ASCII 30 hex (1 byte) in the leftmost byte, and the leftmost
digit of the CompoWay/F command code MRC as ASCII (1 byte) in the right-
most byte. Next, set the bits of S+4 as follows:
Set the rightmost digits of the CompoWay/F command code MRC as ASCII in
the leftmost byte, and the leftmost digit of the CompoWay/F command code
SRC as ASCII (1 byte) in the rightmost byte. Be sure to set one byte each for
the subsequent data without any blank bytes.
×
n bytes ASCII) from leftmost bytes to rightmost bytes
Section 3-7
97