No-Load Operation Test Run - YASKAWA A1000 Series Technical Manual

4.8

No-Load Operation Test Run

◆ No-Load Operation Test Run
This section explains how to operate the drive with the motor decoupled from the load during a test run.
Before Starting the Motor
■
Check the following items before operation:
• Ensure the area around the motor is safe.
• Ensure external emergency stop circuitry is working properly and other safety precautions have been taken.
■ During Operation
Check the following items during operation:
• The motor should rotate smoothly (i.e., no abnormal noise or oscillation).
• The motor should accelerate and decelerate smoothly.
No-Load Operation Instructions
■
The following example illustrates a test run procedure using the digital operator.
Note: Before starting the motor, set the frequency reference d1-01 to 6 Hz.
1. Turn on the power to the drive. The initial display appears.
2.
Press the key to select LOCAL. The LO/RE light will turn on.
3.
Press to give the drive a Run command. RUN will light and the motor will rotate at 6 Hz.
4. Ensure the motor is rotating in the correct direction and that no faults or alarms occur.
If there is no error in step 4, press
5.
increments of 10 Hz, verifying smooth operation at all speeds. For each frequency, check the drive output
current using monitor U1-03. The current should be well below the motor rated current.
YASKAWA ELECTRIC SIEP C710616 27C YASKAWA AC Drive A1000 Technical Manual
Step
to increase the frequency reference. Increase the frequency in
4.8 No-Load Operation Test Run
Display/Result
- MODE - DRV Rdy
FREF (OPR)
U1-01= 0.00Hz
U1-02= 0.00Hz LSEQ
U1-03= 0.00A LREF
JOG FWD FWD/REV
ALARM
DIGITAL OPERATOR JVOP-180
- MODE - DRV Rdy
FREF (OPR)
U1-01= 0.00Hz
U1-02= 0.00Hz LSEQ
U1-03= 0.00A LREF
JOG FWD FWD/REV
F1 F2
LO
ESC
RE
RESET ENTER
RUN STOP
Off On
DIGITAL OPERATOR JVOP-180 ALARM
- MODE - DRV Rdy
FREF (OPR)
U1-01= 6.00Hz
U1-02= 0.00Hz
LSEQ
U1-03= 0.00A LREF
JOG FWD FWD/REV
F1 F2
LO
ESC
RE
RESET ENTER
RUN STOP
RUN
Off
Motor
Forward
4
RUN
On
121