Table 2-3 | Signals And Pin Out Of The Rs-232 Connector - Acom 700S User Manual

User's Manual | ACOM 700S | 1.8-54 MHz Linear Amplifier
b) RS-232 interface connector
Please, see
Figure 2-4 | Rear panel - Connections
RS-232 interface is used for Firmware Updates (see Section
Section
6 REMOTE CONTROL
RS-232
Pin Nr.
interface
1
2
3
4
5
D-sub
6
connector,
7
9-pin,
8
female
(Rear panel
9
view)
April 2024
, Pos. (4).
).

Table 2-3 | Signals and pin out of the RS-232 connector

Pin name
- Not connected
TxD Transmit Data
RxD Receive Data
- Not connected
GND Ground
DSR Remote Power On
- Not connected
CTS Remote Power On
- Not connected
Table 2-3 | Signals and pin out of the RS-232 connector
7.5 Firmware
Description
-
RS-232 level output
RS-232 level input
-
0 Volt
RS-232 level input
-
RS-232 level input
-
S e c t i o n INSTALLATION | Page 29 of 92
) and for remote control (see
Specification